Installation Guide

16
STEP 7: LAST ROOF PANELS
Components Needed
 13” wide “W” roof panels (J)
 #10 x 3/8” sheet metal screw
Tools Recommended
FIRST: Begin this step on far LEFT side of
hanging channel when facing the structure
leaving large space from first roof panel. Last
roof panel needs “male” lock edge (see Step
#8) flush to outside edge of hanging channel
and front fascia. Top of panel slide below top
ledge of hanging channel to sit on groove for
screw location.
SECOND: Insert and press last panel firmly
into foam rubber gasket within the hanging
channel interior.
Secure last roof panel with #10 x 3/8” sheet
metal screw through pre-punched hole into
groove location.
THIRD: Secure the last roof panel above the
square post side end with #10 x 3/8” sheet
metal screw attaching to front fascia.
Move square post connected fascia assembly
“side to side” so that last roof panel is square
to fascia board or wall.
NOTE: When attaching to wall (no access from top) attach screws from underside into
bottom flange of hanging channel (not into screw groove) using #10 x 3/8” sheet metal
screws.