Installation Guide

STEP 5: PREPARE POST

Components Needed

 Front fascia (D)

 Bottom post bracket

 Square post (H)

Tools Recommended

A minimum of ½” per foot slope recommended for proper water drainage

FIRST: Slide on & fasten the square post to

the top post connector previously installed to

fascia.

Drill two 3/8” diameter holes through both

post and post connector. Use two 3/8” x 3-

1/2” bolt & nuts to fasten.

SECOND: Front fascia profile shown must be

“level” across width of patio cover.

Roof Panel must not touch front fascia wall to

allow for water to flow into front fascia drains.

Insert foam fascia dams at end & seal

generously.

Secure roof panel to front fascia rail with

screws from above center of panel “valley”.

THIRD: Raise the assembly into position and

temporarily stabilize the front fascia & post in

upright position by tying each end post to

each ladder with a rope or cord. DO NOT

attach post to patio surface until proceeding

to next STEPS and ensuring first roof panel

insert is “squared” to front fascia and post

assembly.

NOTE: Uneven patio surface will require varying lengths of each post across uneven surface.