Installation Guide

TWV Series Patio Cover
Installation Guide
Step 6-J: Running the Roof Panels & Pre-Formed Flashing
Now you have 3 Roof Panels started on the right side. Take one Pre-Formed Flashing, holding
it upright so the 5/16” leg is aligned into the Flashing Groove in the Hanging Rail. Slowly lower
the Flashing down to the Roof Panel. Bend the tabs downward to go into the Roof Panel grooves
to block leaves.
Step 6-K: Running the Roof Panels & Pre-Formed Flashing
Put a dab of Caulk Sealant under the first notch on the right where it rests on the roof panel.
Fasten through the Flashing into the Roof Panel top using one #8 tek screw. Then put another
dab of Caulk over the screw head.
28