Installation Guide

Need help with installation? www.homedepot.com/services/pergola-installation/
STEP 8: SNAPPING PANELS
Components Needed
 13” wide “W” roof panel (J)
 #10 x 3/8” sheet metal screw
 Sealant tube & gun
Tools Recommended
FIRST: YOU MUST ALWAYS ADJUST THE
INTERLOCKING JOINT BETWEEN THE TWO
PANELS TO ALIGN WITH THE 12” MARKS ON
THE HANGING CHANNEL AND THE FRONT
FASCIA.
SECOND: Remove the sheet metal screw
from the installed first roof panel from the
“male” side of panel at the front fascia.
THIRD: Next to installed panel, lay the new
roof panel and slightly lift new roof panel to
overlap “female” lock on top of “male” lock.
Apply downward pressure for tight fit on
entire panel.
NOTE: Each roof panel requires installer to begin by overlaying FEMALE edge over MALE
edge close to the hanging channel. Next, slide the connected edge below the top rail of the
hanging channel and firmly press into foam gasket. Seal generously at all seams.