Installation Guide

THE FORCE

Set-Up and Operation

LECTRICAL CONNECTIONS:

Before connecting the machine to

electrical power, make sure all switches are in the "off " position. Connect

both supplied extension cords to dedicated 115V 20 amp grounded outlets. In

the home, refrigerator or freezer outlets usually fit the amperage requirements.

If necessary, these appliances can be temporarily unplugged, enabling the

FORCE/2 to use the outlet. Disconnecting

these appliances for the short time needed to

operate the FORCE/2 will not cause spoilage.

Remember to reconnect any unplugged

appliance after the job is finished. If your job

requires additional extension cords, make sure you use only a 10/3

cord for a 50 foot run or 8/3 cord for a 100 foot extension.

STARTING:

Operation from the Attic: To use the r

emote control feature for attic

operation, the switches on the main electrical panel must be in the "on"

position. Control the machine using the rocker switch on the remote cord.

Operation from the Ground: To operate the FORCE/2 from the

ground, the rocker switch on the remote control must be in the “on” position.

Operate the blower and agitator from the main electrical panel toggle

witc

hes.

Note: In cold w

ther, your machine is more difficult to start. If

possible, store your FORCE/2 in a warm area over-night before starting this

helps ensur

e the lubricant

(oil) is warm,

enabling the bearings and gearbox to turn

eel

SET-UP AND OPERATION