User's Manual
THE INSTRUCTION FOR XBOX LIVE+GAMEPAD
I．Feature:
1. High technology of CMOS.
2. Working Voltage: 3.5V-6V(3 AAA or 4 AAA valid battery).
3. Working Current: 100mA(the VOICE is on),70mA(the VOICE is off).
4. Wireless transmit frequency: 2.4G.
5. Wireless transmit agreement: Blue Tooth
6. The valid operation distance: 7M.
7. 12-bit ADC inside.
8. Supporting dual-vibration mode.
9. Have “Turbo” function( can’t adjust the speed).
10. The battery lifetime(1800mAh battery): up to 5 hours during vibration, up to 8
hours during no-vibration.
11. The vibration can be exchanged into three levels.
12. 4 LED display on transmitter: Link,Turbo,Mute. 1 LED dispaly on receiver: Link.
II．Operating instructions:
1. Turn on the TV&XBOX console.
2. Place the XBOX game CD into the XBOX console.
3. Open the battery cover at the back of controller&put 3 AAA batteries into it,
insert the headset into the headset jack, turn on the power switch, then
CONNECT LED on the controller will flash.
4. Insert the signal cable on the receiver into the relative game port, the CONNECT
LED on the receiver will flash.
5. After several minutes, if the CONNECT LED on the transmitter&receiver turn to
illuminate, which shows the connection is OK, and you can start to play the game.
6. If the CONNECT LED on the transmitter&receiver still flash after a long
time ,which means the connection is lost, pls restart the above process.
III. Function instruction:
(I) LIVE function
1. Effect: if the played game have the LIVE function, also already connected
with another console through network, so you can turn on the voice function
while you play with your parter.
2. Operation and instruction: press&hold the MUTE key for above 3 minutes,
then the voice function is on, so the MUTE LED will turn to green; restart to
press and hold the MUTE key, the voice function is off and MUTE LED is
off.
(II) MUTE function
1. Effect: when start the VOICE function, if you don’t want your parter to hear
your sound, you can turn off the mike through the MUTE function.
2. Operation&instruction: while the VOICE is on, press the MUTE key, then
the green MUTE LED turn to red, the mike function is off; press the MUTE
key again, The red MUTE LED turn to green, the mike function is on.
(III) HEADSET volume adjust function
You can adjust the HEADSET sound volume by VOLUME button
(IV) VIBRATION function
1. Operation: you can set up the intension both for vibration and
non-vibration through VIB SW, the intension (from left to right) is:
non-vibration----the left&right motor will vibrate by 50%