User's Manual

1 SERVICE AND

Support

1.4 Environmental Requirements

• The printer is for indoor use only.

• The condition of air quality with excessive solid particles (conductive or non-conductive) may

cause damage to the system.

• The system operating temperature shall be kept between 15°C and 30°C (59°F to 86°F), and the

relative humidity shall be kept between 30% and 70% (non-condensate).

• The system storage temperature shall be kept between 0°C and 35°C (32°F to 95°F), and the

relative humidity shall be kept between 20% and 90% (non-condensate).

•

• Please take attention that changes or modification not expressly approved by the party

responsible for compliance could void the user’s authority to operate the equipment.

•

• This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:

• (1) This device may not cause harmful interference, and

• (2) This device must accept any interference received, including interference that may

cause undesired operation.

• This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. This equipment should be installed and operated with minimum distance

20cm between the radiator & your body.

• This device complies with Industry Canada licence-exempt RSS standard(s). Operation is

subject to the following two conditions:

• (1) this device may not cause interference, and

• (2) this device must accept any interference, including interference that may cause

undesired operation of the device.

• Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils

radioexempts de licence. L'exploitation est autorisée aux deux conditions suivantes :

• (1) l'appareil ne doit pas produire de brouillage, et

• (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le

brouillage est susceptible d'en compromettre le fonctionnement.