User's Manual

1 SERVICE AND SUPPORT
2
[PINCH POINT]: It indicates that you may have a risk to pinch hand between two objects. There are one
or multiple objects moving in your working area.
1.2.2 Potential safety hazard area
The following components and areas have been highlighted as having potential safety hazard. Failure to
follow the safety procedure will cause system fault or problem in reliability.
 Nozzle
[HIGH TEMPERATURE] Warning: During the heating of nozzle, please be sure to wear the safety gloves
when maintaining the nozzle or working in the chamber.
 Printing buildplate
[HIGH TEMPERATURE] Warning: During the heating of hot bed, please be sure to wear the safety gloves
when taking off the buildplate glass or working in the chamber.
 Chamber
[HIGH TEMPERATURE] Warning: During the heating of chamber, please be sure to wear the safety
gloves when working in the chamber.
 XY movement frame
[PINCH POINT] Warning: Do not wear tie, loose clothes or hanging ornament when working near by any
moving component of the printer.
Take extra care when maintaining such moving components.
 Z-axis buildplate
[PINCH POINT] Warning: Do not wear tie, loose clothes or hanging ornament when working near by any
moving component of the printer.
Don’t put anything on the bottom of the chamber.
1.3 Door lock
The sensor is used to transmit the state of chamber front door and top door. For safety reason, the
chamber front door and top door must be closed before the chamber is heated or the X/Y/Z motor starts
working. The electromagnetic lock can ensure that the chamber door and cap are firmly closed when the
printer is executing the printing operation.