User's Manual

6 LEVELING
and Calibration
59
Figure 6. 3 XY offset calibration interface
6.2 Auto leveling and XYZ calibration
Auto leveling, mainly by virtue of the sensor installed on the left nozzle, measures the positions of 3 points
on the buildplate, where the printer will determine by itself the relative position of the printing platform
glass and the XY motion plane, and make real-time compensation by raising or lowering the Z axis in the
process of printing. Even if the printing buildplate glass has a certain angle of inclination, the printing can
also be executed by compensation. Same as the manual leveling, the auto leveling is realized by the left
nozzle only.
In the “Material” interface, click “A” button to turn to the auto leveling and XYZ calibration interface. The
three steps from left to right are Leveling, Z calibration and XY calibration respectively.