User's Manual

4 USER INTERFACE
23
Figure 4. 8 Setting interface for preheating and heat maintaining
Check the Preheat check box to enable the preheating, and check the Maintaining check box to enable
the heat maintaining. The default preheating and heat maintaining time is based on the data setting of the
material chamber. To adjust the time, use the sliding bar or "+"/"-", and then click "Change time" to bring
the time into effect.
When the system finds a default, the error code will be displayed in the status bar. An error indication
interface will pop up, including the Error code, error description (Description), and the treatment measure
(Action). After troubleshooting, click "Clear" button to clear the error.
Figure 4. 9 Error indication interface
4.2.2 Auxiliary state area
The auxiliary state area displays the current temperature state of different components. The current
temperature is displayed above the transverse line of temperature display module, under which the target
temperature is displayed. The percentage at the bottom right corner is the progress. Click the extension
button to display the status of extension parameters.
Click “Wl”or “Wr” to calibrate the material weight.