User manual

SGM PilotBox Mounting
3. Connect the control lines to the respective terminals of the connectors analogue to
the power supply.
4. Connect all connectors to the associated sockets at the SGM PilotBox.
 The SGM PilotBox is connected now.
Removing the device from the DIN rail
How to remove the SGM PilotBox from a DIN rail in a switch cabinet:
 You will need a Phillips screwdriver with a 4.5 mm blade.
 All connectors at the SGM PilotBox are detached.
1. Insert the Philips screwdriver into the groove at the bottom of the SGM PilotBox
as shown in the following figure.
25
(similar representation)
2. Turn the Philips screwdriver into the direction of the SGM PilotBox as shown in the
following figure.