Datasheet

Functions and their Configuration INSYS ETHERNET 5.X
48 Nov-06
7.4.4 Firmware flash update
Requirements:
For the flash load function you will need a PC and a terminal program (e.g. TeraTerm,
ProComm, HyperTerminal, etc.).
 The terminal program must be able to perform an ASCII upload (ASCII data
transmission protocol).
 Setting the hardware flow control is mandatory.
 For safety, any interpretation of characters (e.g. TAB, CR, BS …) by the ASCII up-
load protocol must be prevented.
Activation and Process:
 AT** starts the update process for the firmware (flash update).
 After the prompt, the firmware (file extension HEX) must be sent as text file.
 After a successful flash update, the device resets autonomously. This process
may last up to 60 seconds.
Note
To update the firmware, hardware handshake (RTS/CTS) must be activated at the terminal.
The firmware is available as *.HEX file from the technical support department.
 E-mail: [e-mail]
 0941/560061
Pertinent AT commands
AT**
Firmware update of the controller