Datasheet

Functions INSYS GPRS 5.0 serial
46 Mai 06
Alternatively, our example can be set using the terminal program:
In general, activate selective call acceptance
AT**CLIP=1
Enter allowed phone number 1
AT**CLIP1=[phone]
Enter allowed phone number 2
AT**CLIP2=[phone]
Store destination IP for callback
AT**AUTOIP=200.12.0.120
Store destination TCP port for callback
AT**AUTOPORTIP=10000
Store callback settings:
- No callback action for call from phone
number 1
- IP callback for call from phone number 2
- No callback action for call from phone
number 3
AT**CALLBACK=0,2,0
Save the extended functions
AT**SAVE
Activate automatic acceptance of an incoming
CSD call (for the call of a modem in the service
center)
ATS0=2
Save setting for ATS0
AT&W
Perform RESET, accept all parameters
AT**RESET
Note: A connection can be established inde-
pendent from the callback settings via
SMS command (see also Chapter 57 Short
description of the INSYS AT commands)
(provided that the sender number
is stored at
AT**CLIP<index>=<n>).