Datasheet

Commisioning INSYS GSM 4.2 LOGO!
28 Dezember 06
12. Check the field strength of the GSM signal using the Detect GSM intensity button:
The reply should indicate a field strength of at least 12; otherwise, the antennal
must be relocated.
4.4 Troubleshooting
4.4.1 No response to commands
¾ The INSYS GSM 4.2 LOGO! and the terminal (configuration PC or controller)
must operate the serial interface with the same baud rate and data format
(default: 19,200 bits per second, 8N1).
¾ The INSYS GSM 4.2 LOGO! can be reset to the factory settings by holding
down the Reset button (> 25 s).
4.4.2 A connection is not established
¾ Check the signal quality of the GSM network.
¾ Is the INSYS GSM 4.2 LOGO! logged in?
¾ Is the SIM card activated for incoming data connections?
¾ Has the call number been selected for the data connection?
¾ Is there sufficient power supply for transmittal?
4.4.3 Alarm SMS is not transmitted
Was the SMS service center number entered correctly?
¾ Deactivate DTR drop if no device is connected at the serial interface or the
device does not support the DTR function.
¾ Deactivate handshake if no device is connected at the serial interface or the
device does not support the hardware handshake.