Datasheet

AT Command Set INSYS Modem 336/56k 4.1 (UL)
Command Description
AT\B<n> Send “break” to the other modem
For connections that were not error corrected the modem sends a break signal to the
other modem. The length of the signal is: the specified parameter times 1/10 of a second.
For error corrected connections, the modem sends a break signal according to the active
error correction protocol without considering a parameter specification.
If no connection is established or if a fax connection is active, an error message is dis-
played.
AT\B1 1/10 second break signal
AT\B2 2/10 second break signal
AT\B3 3/10 second break signal
AT\B4 4/10 second break signal
AT\B5 5/10 second break signal
AT\B6 6/10 second break signal
AT\B7 7/10 second break signal
AT\B8 8/10 second break signal
AT\B9 9/10 second break signal
AT%B<n> Switch key abort on and off during connection
AT%B0 Key abort is active. Each character on the TX line will result in an interrup-
tion of the connection setup (default)
AT%B1 Key abort is deactivated. The connection setup cannot be interrupted
manually.
A connection setup can only be interrupted via DTR drop, internal canceling of the mo-
dem (NO DIALTONE, BUSY) or Timeout (NO CARRIER). (S-Registry 36 Bit 6)
AT%C<n> Enable data compression
Enable/disable a data compression type
The modem can only perform data compression for error corrected connections.
AT%C0 No data compression enabled
AT%C1 MNP 5 data compression enabled
AT%C2 Enable V.42bis and V.44 data compression
AT%C3 Enable MNP 5 and V.42bis data compression (default)
AT*C Remote configuration password
This password secures the remote configuration as well as incoming data connections
(see AT*P) and security callback.
OLD PASSWORD Requires the old password (default: QWERTY). Wrong input leads to
ERROR.
NEW PASSWORD Enter the new password with 6 to 12 characters.
CONFIRM Repeat the new password. Wrong input leads to ERROR.
OK The password is immediately stored in the EEPROM.
48 July 06