Users Manual Part 6
279
About the DexcomG6 1919 About the DexcomG6
19.6. Communication Messages
e DASHBOARD displays the following communication messages:
• CONNECTING TRANSMITTER:
Occurs aer you have entered a
transmitter serial number and the
Pod is attempting to connect with the
transmitter.
• WAITING FOR DEXCOM SETUP:
When the transmitter is connected
but CGM values
are unavailable because the
Dexcom G6 is in sensor warm-up or requires calibration. See the Dexcom G6
app for details. No action is required within the Omnipod 5 App.
• SEARCHING FOR POD: When Pod communication was not established
within the most recent 5-minute update interval. Tap MORE
INFORMATION for potential causes and recommended actions.
• SEARCHING FOR CGM: When the CGM is active and connected to the
Omnipod 5 Pod but the most recent CGM value was not acquired within the
5-minute window. ere may be no valid CGM value available due to a Pod/
CGM communication issue or a temporary CGM sensor issue (recoverable
without any user action). Tap MORE INFORMATION for recommended
action. Review Pod and CGM placement. Pod and CGM should be at least 3
inches (7.62 cm) apart and within line of sight.
• DEXCOM ISSUE DETECTED: When
CGM values are not available due
to a sensor error (including sensor
expiration). See the Dexcom G6 app
for details. No action is required
within the Omnipod 5 App
• TRANSMITTER ERROR: When the
transmitter connected with the
Omnipod 5 System has expired or experienced a non-recoverable error. Tap
NEED HELP for potential causes and recommended actions. To set up a new
transmitter, see "20.3. Connecting the Transmitter" on page 283.
• TRANSMITTER NOT FOUND: When the Pod tried to connect with a
transmitter but aer 20 minutes was unable to do so. Tap NEED HELP for
potential causes and recommended actions. See "26.3. CGM FAQs" on page 332
for additional information.
Note: For all CGM related issues, refer to your Dexcom G6 CGM System User
Guide