Users Manual Part 1

17
Omnipod 5 Pump Important Safety
Information
Pump Warnings
Omnipod 5 System Settings and
Training
Warning: DO NOT start to use your
system or change your settings without
adequate training and guidance from
your healthcare provider. Initiating
and adjusting settings incorrectly
can result in over-delivery or under-
delivery of insulin, which could lead
to hypoglycemia or hyperglycemia.
Settings that impact insulin delivery
mainly include: Pod Shut-O, basal
rate(s), Max Basal Rate, Max Bolus,
Correction Factor(s), Insulin to Carb
(IC) Ratio(s), Minimum Glucose
for Calculations, Target Glucose
and Correct Above, and Duration of
Insulin Action.
Insulin
Warning: ONLY use rapid-acting
U-100 NovoLog® (insulin aspart),
Humalog® (insulin lispro), and
Admelog® (insulin lispro) insulin in
the Omnipod 5 System as they have
been tested and found to be safe for use
with this system. NovoLog, Humalog,
and Admelog are compatible with the
Omnipod 5 System for use up to 72
hours (3 days). Follow your healthcare
provider’s directions for how oen to
replace the Pod.
Warning: ALWAYS be prepared
to inject insulin with an alternative
method if insulin delivery from the
Pod is interrupted. You are at increased
risk for developing hyperglycemia if
insulin delivery is interrupted because
the Pod only uses rapid-acting U-100
insulin. Failure to have an alternative
method of insulin delivery can lead
to very high glucose or diabetic
ketoacidosis (DKA). Ask your
healthcare provider for instructions for
handling interrupted insulin delivery.
Warning: NEVER use insulin that
is expired or cloudy in the Pod as it
may be damaged. Using damaged
or expired insulin could cause
hyperglycemia and put your health at
risk.
Warning: AVOID administering
insulin, such as by injection or
inhalation, while wearing an active Pod
as this could result in hypoglycemia.
e Omnipod 5 System cannot track
insulin that is administered outside of
the system. Consult your healthcare
provider about how long to wait aer
manually administering insulin before
you start Automated Mode.
Omnipod 5 System
Warning: Device components
including the Pod, CGM transmitter,
and CGM sensor may be aected by
strong radiation or magnetic elds.
Device components must be removed
(and the Pod and CGM sensor
should be disposed of) before X-ray,
Magnetic Resonance Imaging (MRI),
or Computed Tomography (CT) scan
(or any similar test or procedure).
In addition, the Controller and