Users Manual

52
4 Setting Up Your Omnipod5 Application
b. Tap the End Time eld, and enter the new end time for the segment.
c. Tap the Basal Rate eld, and enter the desired basal rate.
d. Tap NEXT.
e. en dene the end time and basal rate for any following segments, as
needed.
4. When the Basal Program is correct, tap SAVE.
5. To add a new segment:
a. Tap the row containing the start time of the new segment.
b. Tap the End Time eld, and enter the start time of the new segment as the
end time of this segment.
c. Change the basal rate, if necessary.
d. Tap NEXT.
e. en dene the end time and basal rate for any following segments, as
needed.
6. To delete a segment:
a. Note the end time of the segment you want to delete.
b. Tap the segment that precedes the segment you want to delete.
c. Tap the End Time eld, and enter the end time of the segment you want to
delete. is 'overwrites' the segment you want to delete.
d. Tap NEXT.
e. en dene the end time and basal rate for any following segments, as
needed.
7. When the Basal Program is correct, tap SAVE.
Note: If the basal rate for a segment is 0 U/hr, the Omnipod 5 app displays
a message calling this to your attention. Tap OK if the 0 U/hr rate is correct.
Otherwise, tap CANCEL and edit the segment with the 0 U/hr rate.
Note: To create additional Basal Programs aer setup is complete, start at page
78 and begin steps again.
Starting
Your
OmniPod 5
Effective Date: 22DEC2020, PCO-000267