User's Manual

Set Up The iXL™ Remote Controller
Chapter 6 describes the remote’s options in detail. The
instructions in this chapter are simplified to help you get started.
Turn on the remote
1. Open the battery compartment on the back of the remote by
gently pressing down on the ribbed side of the compartment
door until it opens (Figure 2-1). No special tools are necessary.
2. Insert two (2) new AAA alkaline batteries into the
compartment.
The diagram inside the compartment shows you which
direction to insert the batteries.
Use only new AAA alkaline batteries to power the
remote. Never use old or used batteries; the remote
may not work properly.
3. Replace battery door.
4. Turn the remote face-up.
5. Press the Power button.
The iXL™ Setup Wizard
The first time you turn on the iXL Remote Controller, the Setup
Wizard comes on automatically. Although setup is easy with the
Wizard, if you are a first-time user, your healthcare provider
must guide you through the process. Setup takes only a few
minutes and is easy to do:
• Use the Up/Down Controller button to increase or decrease
a number or to move up or down a list.
• Press the soft key labeled Next to continue to the next screen.
• Press the Back soft key to return to previous screens.
You can adjust these settings later as your needs change
or you fine-tune your iXL System.
10 iXL™ Diabetes Management System User Guide: Getting Started
Getting Started2
Figure 2-1