Operation Manual

8
InStyler
®
Wet 2 Dry Rotating Iron
SafetyFirst-Using your Thermal Guard
NOTE: It is recommended that you use your InStyler with the included
Thermal Guard Training Aid, to help prevent burns while you are getting
used to this unique new hot styling tool.
AttachingYourThermalGuardTrainingAid
1. BeforeattachingtheThermalGuardmakesurethebarreloftheunitiscoolto
touch.
2. Toattach,snaptheThermalGuardTrainingAidontothesideoftheunit
directly under the ring below the barrel.
3. RotatetheThermalGuardTrainingAiduntiltabsareseatedintheindentations
onthebodyoftheInStyler,andtheThermalGuardTrainingAidisfacingout.
4. Onceitissnappedinplace,youcanuseyourInStylerasyounormally
would.
RemovingYourThermalGuardTrainingAid
5. BeforeremovingThermalGuardmakesurethebarreloftheunitiscoolto
touch.
6. ToremovetheThermalGuardTrainingAid,rmlygrabtheThermalGuard
Training Aid, making sure the barrel of the unit is cool, twist to unseat it and
pull to remove.
NOTE: It is important to keep your InStyler clean, as hair product build-up can
accumulate on the barrel and bristles. With the unit unplugged, wipe the outside
surface only with a lightly damp cloth. Bristles can be lightly scrubbed if neces-
sary. Make sure the InStyler is completely dry before plugging into any power
source. Please see page 19 of this manual for more detailed instructions on
cleaning.
*Always allow the InStyler Wet 2 Dry to cool before storing.