Use and Care Manual

Table Of Contents

Countertop Basin Installation

Cut holes if necessary for waste and tap Seal the inside/exposed edge after

cutting to prevent water/moisture

penetration

Apply a bead of silicone slightly in

Fit basin waste (Not included) to

basin, following the waste instruction

from the edge of the basin

Correct application Incorrect application

Place basin into position over the hole

in the unit top and leave for at least

24 hours to allow the silicone to dry

Failure to seal the basin in this way will invalidate any guarantee

PAGE 1
Countertop Basin Installation 1 2 Cut holes if necessary for waste and tap Seal the inside/exposed edge after cutting to prevent water/moisture penetration 4 3 Fit basin waste (Not included) to basin, following the waste instruction Apply a bead of silicone slightly in from the edge of the basin 5 Correct application Incorrect application 6 Place basin into position over the hole in the unit top and leave for at least 24 hours to allow the silicone to dry Failure to seal the basin in this way
PAGE 2
Care and Maintenance Solid Surface has a nonporous surface that makes it resistant to stains, scratches and discoloration. To maintain the condition of your new Solid Surface tub, simply wipe the surface with a dry, soft cloth after each use. Most dirt and dust will wash off with clean, warm water. For a more thorough cleaning, be sure to use a mild cleaner such as a gentle dish soap. Avoid any products that contain abrasives, acids, or ammonia.