Installation Guide

SPLICING CORNERS

One end of the strip

will butt against the

adjacent wall.

Cut the beginning end of

the next strip to make a

45º compound angle.

Optional: Apply a small dab of

permanent glue where the

adhesive has been cut away

Overlap the strip that is

in place and continue

installation.

REMOVE OLD SILICONE * * * InstaTrim WILL NOT adhere to leftover silicone residue. * * *

Using a sharp blade or caulk removal

tool, cut caulk away from the surface

and peel away as much old caulk as

you can.

Using acetone or silicone remover with

a stiff brush or scrubby sponge, scrub all

remaining silicone oils and residue from

surface. Do not use mineral spirits.

Wipe surface with a soft cloth and

acetone or silicone remover again to

remove any remaining oils and

residue. Let dry completely.

NOTE: Always use ventilation in enclosed areas with any solvent cleaning solution.

SPLICING TWO ENDS

Cut the ﬁnish end of the

1st strip at a 45º angle.

Optional: Apply a small dab of

permanent glue where the

adhesive has been cut away.

2 3

Cut the beginning end of the 2nd strip at a 45º angle

in the opposite direction so the ends will overlap and

create a smooth transition between the strips.

How-to Videos and Other Helpful Tips Online at www.instatrim.com