Installation Guide

MEASURE – Lay the new trim strip along the application area to determine the length needed. Before cutting, add 1/8 inch.

Cut with a razor blade or scissors.

PEEL – Locate the thin plastic release liner that covers the adhesive and peel back about 12 inches of liner.

PRESS – Line up the end of the strip with the end of the application area and lightly press it into place every 3-4 inches along

the strip, pulling back additional liner as you work. If the placement isn’t quite right, you can pull the strip back from the surface

to re-align. CAUTION: Do not pull or stretch InstaTrim while you work as this may cause the ends to shrink back over time.

APPLY FIRM PRESSURE – Once the trim is set into place, use FIRM pressure to push it into the corner, every 1-2 inches

along the strip. Then go over the entire strip again with FIRM pressure to ensure the adhesive has spread and adhered onto the

application surface. We recommend using the InstaTrim Applicator Tool to make installation even easier.

is a registered trademark of CornerFlex, Inc.

U.S. Patent Nos: 9,765,960 – 9,783,999 – 10,054,304 – 10,550,584 - 11,193,668. Additional Patents Pending

CORNER AND END TRIM PIECES - Correctly splicing

corners is challenging and may take a lot of practice to do so

correctly. Our new trim pieces make it quick and easy to finish

inside and outside corners and to hide exposed trim ends, and

leave you with a smooth professional finish.

APPLICATOR TOOL - The key to installing InstaTrim

is that you need to press the strip firmly enough into

the surface to cause the adhesive to spread

and grab onto the surface area.

The Applicator Tool’s ergonomic

handle makes it easy on your hands

and assists in appling firm pressure

for the final step of installation.

QUICK & EASY STEPS TO THE PERFECT INSTALLATION

SPLICING TWO STRIPS IN-LINE

INSTATRIM ACCESSORIES