User Manual

21
Problem Possible Reason Soluon
1
Dicult to close the lid
Sealing ring not installed
properly
Posion the sealing ring
well
Float valve in the popped-up
posion
Press the oat valve lightly
downwards
2
Dicult to open the lid
Pressure exists inside the
cooker
Use the steam release han-
dle to reduce the internal
pressure. Open the lid aer
the pressure is completely
released.
Float valve stuck at the
popped-up posion
Press the oat valve lightly
with a pen or chopsck.
3
Steam leaks from the
side of the lid
No sealing ring Install the sealing ring
Sealing ring damaged Replace the sealing ring
Food debris aached to the
sealing ring
Clean the sealing ring
Lid not closed properly Open then Close the lid
again
4 Steam leaks from oat
valve for over 2 minutes
Food debris on the oat valve
silicone seal
Clean the oat valve sili-
cone seal
Float valve silicone ring worn-
out
Replace the oat valve sili-
cone ring
5 Float valve unable to
rise
Too lile food or water in
inner pot
Add water according to the
recipe
Float valve obstructed by the
lid locking pin
Close the lid completely,
see “Cooking Preparaon”
secon
6
Steam comes out from
exhaust valve non-stop
Steam release handle not in
sealing posion
Turn the release handle to
the sealing posion
Pressure control fails Contact support online
7
Display ashes “Lid” Lid is not at the correct posi-
on for the selected program
Close lid for pressure cook-
ing or open the lid for sau-
téing
8
Display shows “noPr” Working pressure is not
reached during pre-heang
cycle.
If the lid leaks steam,
please see Problems 3, 4, 5
and 6. If there is no steam
leaking and you have frozen
food in the cooker, please
run the current program
again.
9
Display shows “Ovht” Overheang is detected on
the inner pot
Please stop the program
and check if the food at the
boom of the inner pot is
burnt.
Troubleshoong Table