User Manual
Table Of Contents
- IMPORTANT SAFEGUARDS
- Special Cord Set Instructions
- Initial Setup
- Product, Parts and Accessories
- Control Panel
- Smart Program Settings
- Reset Smart Programs to Factory Default Settings
- Adjust and Save Custom Temperatures
- Reheat Food or Keep Warm for Long Periods
- Status Messages
- Cleaning Before First Use
- Overview of Pressure Control Features
- Steam Release Valve
- Anti-Block Shield
- Sealing Ring
- Float Valve
- Condensation Collector
- Depressurizing the Cooker (Venting Methods)
- 10-Minute NR
- Initial Test Run (Water Test)
- Smart Programs: Non Air Frying
- Sauté
- Slow Cook
- Sous Vide
- Sous Vide Cooking Guidelines
- Smart Programs: Air Frying
- Bake
- Roast
- Broil
- Dehydrate
- Smart Program Overview
- Cooking Time Chart
- Care and Cleaning
- Troubleshooting
- Warranty
48
Smart Programs: Air Frying
9. Press Start to begin. The display reads On to indicate that the cooker has
begun Pre-heating.
10. When the cooker reaches the target temperature, On changes to the cooking
countdown timer.
11. Part way through the cooking cycle the display indicates turn Food.
12. Lift the air fryer lid off the Instant Pot cooker base and place it on the
protective pad provided.
Note: Lifting the lid automatically pauses cooking for 3 minutes. After 3 minutes the
program will stop, and the air fryer lid will go into Standby mode.
13. Carefully turn, ip, or rotate your food.
14. Close the lid as described in step 5.
Note: Some food does not require turning. If the lid is not removed after the turn Food
indicator appears, cooking will proceed after 10 seconds.
15. When there is 1 minute left, the timer counts down the remaining cooking
time in seconds.
16. When the Smart Program completes, the lid beeps, and the display indicates End.
Note: The air fryer lid beep after 5 minutes, 20 minutes, and 60 minutes to remind you
that cooking has completed.
CAUTION
To avoid personal injury or damage to property, only place the lid on the protective
pad provided.
WARNING
Do not overll the inner pot or accessories. To prevent risk of re, damage or
personal injury, ensure that food contents do not make contact with the heating
element or the element cover.
WARNING
If the sensor connectors on the air fryer lid and cooker base are not fully connected,
the display will indicate C9. Failure to ensure a proper connection could result in
damage to the cooker.