User Manual

7
Getting Started
7
Remove & Install Float Valve & Silicone Cap
Remove: Detach
silicone cap from oat
valve and remove from
top of lid. Do not discard.
Install: Drop oat valve
into top of lid. Attach
silicone cap to bottom
of oat valve.
Down: Cooker is
depressurized
Up: Cooker is
pressurized
8
Remove & Clean Inner Pot
9
Secure Power Cord
Remove inner pot from cooker base and
wash before rst use. Wipe outer surfaces
of inner pot and heating element to
ensure they are dry and free of debris.
Secure detachable power cord to
base power socket. Connect to a 120V
power source. Cooker will display
“OFF” to indicate Standby mode.
To disconnect, press
Cancel then remove plug
from power source.
CAUTION
While oat valve is up, contents of cooker are pressurized. Do not attempt to remove lid. Refer to “Venting
Methods” for releasing pressure.
CAUTION
To avoid risk of personal injury and/or property damage, do not pour food or liquid into cooker base. Always
cook in an Instant Pot inner pot.
5
Remove & Install Anti-Block Shield
6
Check Sealing
Ring & Sealing Ring Rack
Remove: Grip lid and press rmly against side
of anti-block shield (pressing towards side of lid
and up) until it pops off prongs underneath.
Install: Place anti-block shield over prongs
and press down until it snaps into position.
Remove: Pull sealing ring out from
behind sealing ring rack.
Install: Place sealing ring over sealing ring rack
and press into place. Ensure sealing ring is tight.