Measurement Guide

Window Film
Installation Instructions
1. Prepare the surface. Surface should be clean and
free of dust.
2. Fill a pump or trigger-spray bottle with water
( soapy water recommended). Generously spray
water, on the window until beads of the water run
down the glass. If the window becomes dry, rewet it
completely before applying film. Too much water is
better than not enough.
3. Remove the liner at the back of the window film.
Apply the adhesive side of the film to the wet glass.
Start at the top of the window, and then allow the
film to gently lay down onto the glass. Work from top
to bottom and use your hands to smooth the film
onto the glass.
4. Wet the top of the film and remove the air bubbles
by pressing firmly on the window film. Start about 2”
from the top and side and squeegee from left to
right, but leave the 2” perimeter area unsqueegeed.
If you need to remove large air pockets, rewet the
top of the film and squeegee again.
5. Trim the edges of the window film if any and then
finish all the edges around the window.
6. And lastly…we would highly appreciate if you can
take a moment to send us a picture of your project
at [e-mail]
Questions? – Call Us: 1 855 855 8880