Installation & Assembly

CLOTHES STORAGE SYSTEM
Model # AH3X12
Frequently Asked Questions
Q – Why does the end of the InstaHANGER rod seem difficult to remove from the entry slot of the sliding channel?
A – The entry slot was designed that way so that the end of the rod will not eject easily or unintensionally when
opening the unit. The stiffness will not damage the InstaHANGER.
Q – Why does there appear to be excessive lateral or side movement of the InstaHANGER bracket when opened?
A – For safety concerns against accidental injury, the unit was designed to give way rather than stand too rigid
when opened.
Q – Can the QuikCLOSET be closed against the wall with the telescopic rod attached to the InstaHANGERS?
A – No, the QuikCLOSET was not designed that way. You will find however that after continued use, the
telescopic rod removes or installs easily in just a few moments.
Q – Why is the QuikCLOSET so strong even though it’s brackets are made of plastic?
A – The plastic used is ABS which is an extremely strong & durable plastic. The same plastic that is used for
among other commercial or industrial uses, fabricating plumbing drain pipes & fittings. The steel tubing of
the telescopic rod is heavy gauged & designed for free support. Also, the triangle is the strongest shape
known to man. Trusses and bridges are designed by using a series of triangles to span unsupported for great
distances. Put these three features together and the result is a light weight and very strong closet system.
Q –Why is it when I installed the base of the InstaHanger against the wall, the cover section will not stay attached?
A – This is a common question. Assembling the cover to the base can be confusing. The quickest way to know if
the base has been installed correctly is by looking next to the sliding channel of the base section. If you can
read the patent numbers and the country of origin, then the base has been installed backwards. Simply slide
the base off of the screws & turn it over so you cannot see the printing. To install correctly, attach the base to
the cover as shown on the line drawing of the marking template. The hinge pins at the top of the cover should
slip in behind the hinge cups at the top of the base. Those two cups will hold the hinge pins against the wall and
the cover to the base sections. Simply slide the assembled parts on to the mounting screws & tighten snugly.
Q – Once I have installed the InstaHanger to the wall, why can't I access the top screw to tighten it.
A – You must lift the cover up high enough. To do so, pull the end of the hanging rod out of the entry slot of the
sliding channel. Once out, use the rod to push the cover up high enough to access and tighten the top screw.
Once tightened, push the end of the hanging rod back into the entry slot. Lift the rod in the track to close
the cover flat against the wall.
Q – Can I paint my InstaHanger?
A – Yes you can with the proper paint for plastic. Krylon brand paints make a product called "Fusion". This paint
will bond to the plastic InstaHanger. They have a variety of colours available.
For more information call:
[phone] or [phone]
www.instahanger.com
InstaHANGER and InstaHANGER QuikCLOSET are manufactured for Arrow Hanger Division of 1033511 Ontario Inc.PO Box 2042 Richmond Hill, ON L4E 1A3 Canada Made in China
Congratulations! You have purchased one of the most innovative clothes storage systems on the market today.
QuikCLOSET’s space saving design will allow you to use only the required hanging space that you need at any
given time, whether it be 12”, 24” or up to 48” of heavy duty clothes storage space.
Once installed, just open one InstaHANGER bracket for 12” of space, open the 2nd InstaHANGER for a total of
24” of hanging space. By joining the two brackets with our durable telescoping hanging rod, you will create an
instant 100 lb. capacity QuikCLOSET, in seconds!
QuikCLOSET requires absolutely no floor space creating a “Clutter Free Zone”
This versatile storage system replaces a typical floor standing garment rack that occupies 8 – 10 sq. ft. of floor
space, a welcomed feature particularly in smaller rooms where maximum floor space is a necessity.
Creates 3 to 5 ft. of clothes storage space
Quickly & Easily!
• Create an instant closet anywhere!
• Organize the laundry room
• Store and cycle your seasonal clothes
• Maximize your existing closet space
• Installs at any convenient height
Installation Technique
*
NOTE: Maximum spacing between 2 InstaHANGERS for heavy clothes storage is 4 FT. (Hollow drywall installation
is NOT recommended for this application). Maximum spacing between 2 InstaHANGERS for drying or ironing
storage (for example – laundry room use or by the pool) is 5 FT.
1. Install two InstaHANGERS at required or desired height (refer to back of Installation Template for
InstaHANGER Installation Instructions).
2. Set InstaHANGERS in their open position with hanging rods positioned horizontally.
3. Extend the telescopic hanging rod longer than necessary & temporarily rest the rod onto the kinked portion
(resting position) of both InstaHANGER hanging rods.
4. On one InstaHANGER, remove the end of the hanging rod from the wall mounted
section by sliding the rod up & out of the entry slot of the molded sliding channel
with one hand, while holding the end of the telescopic rod with your free hand.
5. Simply slide the slotted end of the telescopic rod over the end & onto the
InstaHANGER hanging rod. Now reinsert the end of the hanging rod back into
the entry slot & allow it to slide back down to its resting place.
6. Repeat steps 4 & 5 with the other InstaHANGER.
7. Slide the telescopic rod along the hanging rods to the kinked resting position.
QuikCLOSET has been tested to 100lbs. capacity & will provide years of
service under normal load conditions. Avoid Overloading
.
*NOTE For best results,
allow 12” of clear wall
space on either side of the
QuikCLOSET to provide
hanger clearance for each
InstaHANGER bracket when
the telescopic rod is not
being used.
Example - For a 48” wide
QuikCLOSET, allow 72” of
clear wall space.
Creative Storage Installation Guide
Please read all instructions thoroughly before beginning the installation.
Sleek and Tidy Some Storage Outdoors
More Storage Lots of Storage
SYSTÈME DE RANGEMENT POUR VÊTEMENTS
Modèle n
o
AH3X12
Félicitations! Vous venez d'acheter l'un des systèmes de rangement pour vêtements les plus novateurs actuellement
sur le marché.
Que vous ayez besoin de 30 cm (12 po), 60 cm (24 po) ou jusqu'à 120 cm (48 po) d'espace robuste pour ranger vos
vêtements, la conception compacte de QuikCLOSET va vous permettre de n'utiliser que l'espace de suspension dont
vous avez besoin au moment où vous l'utilisez.
Une fois installé, il vous suffit d'ouvrir une console d'InstaHANGER pour obtenir 30 cm (12 po) d'espace. Ouvrez alors
le second InstaHANGER pour obtenir un espace de rangement total de 60 cm (24 po). En reliant les deux consoles à
l'aide de notre tige de suspension télescopique durable, vous créerez instantanément un système de rangement
QuikCLOSET d'une capacité de 90 kg (100 lb), et ce en quelques secondes!
QuikCLOSET ne nécessite absolument aucun espace de plancher, ce qui vous
permet de profiter d'un « espace non encombré »
Ce système de rangement polyvalent remplace un porte-vêtement ordinaire qui se pose sur le plancher, où il occupe
alors 75 à 90 centimètres carrés (8 à 10 pieds carrés) d'espace de plancher. Ce système est donc particulièrement le
bienvenu dans les pièces à superficie réduite où maximiser l'espace plancher est une nécessité.
Crée 3 à 5pi (1-1,5M) d’espace de rangement pour le linge
Rapidement et facilement!
• De créer une armoire instantanée n’importe où !
• D’organiser la salle de lavage
• D’entreposer et recycler vos vêtements saisonniers
• De maximiser votre espace d’armoires actuel
• S’installe à n’importe quelle hauteur pratique
*Remarque : pour obtenir un
résultat optimal, laissez 30 cm
(12 po) d'espace libre au
niveau du mur, de chaque côté
du QuikCLOSET, afin de laisser
un espace de suspension
adéquat pour chaque console
InstaHANGER lorsque vous
n'utilisez pas la tige téle-
scopique. Par exemple - pour
un QuikCLOSET de 120 cm (48
po) de largeur, prévoyez 180
cm (72 po) d'espace libre au
niveau du mur.
Guide d'installation du système de rangement créatif
Veuillez lire toutes les instructions attentivement avant de commencer l'installation.
Peu encombrants
et pratiques
Un peu d’espace
de rangement
À l’extérieur
Beaucoup d’espace
de rangement
Beaucoup d’espace
de rangement
=
Patent – CA – 2,268,510
US – 6,464,091 B1
=
RPUR114
QUALITY PRODUCTS