Installation & Assembly

Step III. Place the table top (J) upside down on a flat, soft, non-abrasive
surface. Remove and discard the 4 screws that are inserted into the table
top. Connect the support frame (H) to the table top (J) by using: spring lock
washer (D), 50MM screw (K), hex wrench (I). Do NOT tighten the screws until
all have been inserted. Once all screws have been inserted, securely tighten
each of the screws using the hex wrench (I) and then insert the screw covers
(L). At least 2 persons should very carefully lift the table in unison to turn it
right side up. See Figure 3.
Assembly Instructions Counter Table Base for 40” Round Stone Tops Model # 10010040a
Page 2
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
For questions, missing parts or defectives,
please contact Peak Season:
1-866-563-1732
[e-mail]
Hours of Operation: 8:00 a.m. to 5:00 p.m. CST
Figure 2
Figure 3