Use Instructions

ENGLISH 21
 Turn the device on with the Power-button, located top of the monitor (7). The monitor unit (7)
can be removed from the basic device for optimal viewing angle.
Excessive pressure on the touch screen may damage the monitor unit!
 Remove the camera head (1) from the holder (8) and pull the cable (4) from the reel (6). The
cable is rigid and is under mechanical stress. Therefore, hold it firmly when unwinding from
the reel.
 Guide the camera head (1) into the pipe system and carefully push it with the cable (4).
Caution: Unwinding the reel too quickly may cause it to continue to spin.
 Camera heads are interchangeable.
Do not pull the cable (4) over sharp edges, and do not bend it!! Check the camera cable
before each use for damage!
While it is being pushed, the cable (4) may loop: Breakage may result!
During advancement through several pipe bends, the camera image is always upright.
 After work is finished, pull the cable (4) out of the pipe and push it directly onto the reel (6).
Remove coarse dirt and water with a rag while winding cable on reel.
 Clean thoroughly (see section 5).
 Dismantle camera head (1) and accessories, plug cap and insert bending spring (3) with rell
cable (4) into the reel (6).
 Camera head (1) and accessories should be cleaned and safely stored.
Camera head and accessories must be cleaned after each use, dismantled and stored
safely. Abnormal transport of the camera head can cause damage!
 Check the camera head regularly the camera head (1) for leaks. For this purpose, screw the
test adaptor on the camera head, applying a maximum pressure of 1 bar by an air pump
with pressure indicator. If this test indicates a drop in pressure, replace camera head.
4.5 ROCAM positioning
The positioning probe is built in the camera head spring. The positioning probe emits magnetic
fields that are received by the positioning receiver and are transformed visually and audibly.
The 33 kHz measuring system can penetrate masonry, stone, wood and plastic.
The intensity of the signal changes depending on the position and distance from the receiver.
4.6 Monitor unit with touchscreen
The ROCAM mini HD comes with a SD card to save photo's and video's. This can be removed
for data transfer.
Connections HDMI, mini USB and SD card are on the bottom monitor unit