Installation Instructions

Prepare your walls
* remove dirt, debris, loose paint, anything that
would affect the adhesive bond
* if unsure of wall condition, perform an adhesive
test (see website for details)
Start in a corner
* run a ⅜” bead of adhesive along the dovetailed
gluing surface of all three studs of a full panel
* apply an extra bead of adhesive directly to the
foam within 2” of the corner of the wall
* press the panel firmly into place, repeat the
process on the adjacent wall. fill out the first row.
Create the interlock pattern
* after placing the first row of panels, cut a panel
along the cutting/channel line into a 16“ and 32”
section
* to create the second row, adhere the 32” section
directly above the first row panel
* eliminate waste by using the remaining 16“
section to start the second row on the adjacent wall
Outside corners
* cut panel flush with the corner, use the remainder
of the panel to continue around the corner
* apply a bead of adhesive along the foam edge
where the two panels meet and an additional bead
of adhesive to adhere the panels to the concrete
wall
* adhere metal corner for easy drywall and corner
bead attachment
Windows and Openings
* Prepare all openings with wood furring that meets
the thickness of the panel
* use a knife or saw to fit panels around openings
Electrical
Cutting an outlet box
* press an outlet box firmly into the foam to make
an impression, then remove foam with a knife
* cut a pathway to run wiring from the box opening
to the horizontal or vertical chaseway
Prepare your walls
* remove dirt, debris, loose paint, anything that
* remove dirt, debris, loose paint, anything that
Outside corners
* cut panel flush with the corner, use the remainder