Installation Instructions

ManualsBrandsInSoFast ManualsBuilding materialsUX 2.0 R-8.5 EPS Foam Board Insulation Panels - 40 sq. ft.

for InSoFast UX 2.0 and EX 2.5 panels

Interior Adhesive Installation

Please note: This guide visually depicts the adhesive

installation of UX 2.0 panels for the purpose of clear stud

visibility. The installation of EX 2.5 panels follows the

same formula. Differences arise in the thickness of the

panels where the depth of opening jambs, outlet boxes,

etc. should be considered.

To get more detailed information, visit our website at

www.insofast.com, or call us at (888) 501-7899

Made in USA, US Patent No. 8,635,824 & Patent Pending

approved adhesive

What you will need

* Loctite PL Premium® 3X Stronger Polyurethane

Construction Adhesive in 28oz. tube with caulk gun,

or concrete screws or nails

-- do not use powder-actuated tools

* utility knife with long, snap-off blades

* chalk line, tape measure, sharpie

* hand saw, or power saw

* expanding spray foam

Summary of content (4 pages)

PAGE 1
Interior Adhesive Installation for InSoFast UX 2.0 and EX 2.5 panels What you will need * Loctite PL Premium® 3X Stronger Polyurethane Construction Adhesive in 28oz. tube with caulk gun, or concrete screws or nails -- do not use powder-actuated tools * utility knife with long, snap-off blades * chalk line, tape measure, sharpie ve * hand saw, or power saw si e * expanding spray foam dh ap p ed v ro a To get more detailed information, visit our website at www.insofast.
PAGE 2
Foam Insulation High density injection molded polystyrene (EPS) insulation closed-cell closed * it can easily be cut‚ carved or grooved with a simple utility knife to ﬁt any obstacle or protrusion Attachment Stud Strong reinforced composite studs are cast into the insulation; a much more durable alternative to wood framing as it won’t warp, bow, twist, shrink, shrink mold, rot, or decay * studs can easily be cut with a hand or power saw Cutting/Channel Line Located 16” on center indicating the location
PAGE 3
Prepare your walls * remove dirt, debris, loose paint, anything that would affect the adhesive bond * if unsure of wall condition, perform an adhesive test (see website for details) Start in a corner * run a ⅜” bead of adhesive along the dovetailed gluing surface of all three studs of a full panel * apply an extra bead of adhesive directly to the foam within 2” of the corner of the wall * press the panel ﬁrmly into place, repeat the process on the adjacent wall. ﬁll out the ﬁrst row.
PAGE 4
Inside Corners * cut panel short to leave a ¼" gap in the corner * continue around corner with the cut off remainder to maintain interlock pattern * apply an extra bead of adhesive directly to the foam within 2" of the corner Floor and Ceiling * for best practice, caulk or seal the panels at the floor, ceiling, corners, electrical outlets and any other penetrations or openings Windows and Openings * extension jambs should be made flush with drywall * finish openings as usual with standard trim or drywall El