Use and Care Manual

Latex Traffic Paint TP-22XX
Manufactured by Benjamin Moore & Co. 101 Paragon Drive, Montvale, NJ 07645 Tel: [phone] Fax: [phone] www.Insl-x.com M72 TP-22XX EN 041019
© 2017, 2019 Benjamin Moore & Co. All trademarks belong to their respective owners All rights reserved
Surface Preparation
Surface to be marked must be clean, free of dust, oil, grease, wax,
rust or bleeding stains. Any asphaltic seal coat applied to the
surface prior to application of this traffic paint should be dry for at
least 48 hours before this traffic paint is used. Existing traffic lines
can be obliterated on asphalt surfaces by coating with TP-2220
Black Latex Traffic Paint prior to application of the required color.
WARNING! If you scrape, sand, or remove old paint, you may
release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD DUST
CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE,
ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD
ALSO AVOID EXPOSURE. Wear a NIOSH approved respirator to
control lead exposure. Clean up carefully with a HEPA vacuum and
a wet mop. Before you start, find out how to protect yourself and
your family by contacting the National Lead Informational Hotline at
1-800-424-LEAD or log on to www.epa.gov/lead .
Application
Latex Traffic Paint may be applied by brush, roller, spray, hand or
automatic line markers. Do not apply when air or surface
temperatures are below 50 °F. Do not paint if surface temperature is
within 5°F of the dew point. Do not apply to extremely hot surfaces.
Stir contents thoroughly from the bottom before using. Paint only in
dry weather. Thinning is not normally recommended; if necessary
thin sparingly with clean water. This Latex Traffic Paint will dry to
touch (ASTM-1640, 8 mils) in 30 minutes at 72 °F. Dry to no pickup
(ASTM D-711, 15 mils) occurs at 45 minutes at 72 °F. Latex Traffic
Paint is not designed as an anti-slip coating. If skid resistance is
important, apply Insl-x
®
Sure Step
®
**
**Actual spread rate will vary based upon numerous factors,
including texture of the substrate, application method, waste,
surface porosity and thinning. The Theoretical Spread Rate listed on
this document has not taken into account these factors and is only
based upon the volume solids of this product and the recommended
wet film thickness when applied to a smooth substrate.
Clean up
Warm, soapy water.
USE COMPLETELY OR DISPOSE OF PROPERLY. Dry empty
containers may be recycled in a can recycling program. Local
disposal requirements vary; consult your sanitation department
or state-designated environmental agency on disposal options.
Environmental Health & Safety Information
Use only with adequate ventilation. Do not breathe spray mist or
sanding dust. Ensure fresh air entry during application and drying.
Avoid contact with eyes and prolonged or repeated contact with
skin. Avoid exposure to dust and spray mist by wearing a NIOSH
approved respirator during application, sanding and clean up.
Follow respirator manufacturer’s directions for respirator use. Close
container after each use. Wash thoroughly after handling.
WARNING Cancer and Reproductive Harm–
www.P65warnings.ca.gov
In case of eye contact, flush immediately with plenty of water for at
least 15 minutes; for skin, wash thoroughly with soap and water. If
symptoms persist, seek medical attention. If you experience
difficulty breathing, leave the area to obtain fresh air. If continued
difficulty is experienced, get medical attention immediately.
IN CASE OF SPILL – Absorb with inert material and dispose of as
specified under “Clean up”.
KEEP OUT OF REACH OF CHILDREN
PROTECT FROM FREEZING
Refer to Safety Data Sheet for
additional health and safety information.