Use and Care Manual

Manufactured by Benjamin Moore & Co. 101 Paragon Drive, Montvale, NJ 07645 Tel: [phone] Fax: [phone] www.Insl-x.com M72 TP-22XX EN 041019
LATEX TRAFFIC PAINT
TP-22XX
Features
General Description
 Interior/Exterior
 Dry To Touch In 30
Minutes
A fast drying paint for marking traffic lanes on streets,
highways, parking lots, warehouses and other areas where
such marking is required. Traffic beads may be dropped into
this coating while wet to provide light reflecting markings. If
beads are applied, they should be broadcast into the wet paint
at a rate of 6 pounds of beads per gallon of paint.
Recommended For
Limitations
For use on concrete and asphalt on interior or exterior
horizontal surfaces such as streets, highways, parking lot or
warehouses.
 Do not apply when air or surface temperatures are below
50 °F (10 °C)
 Do not apply to extremely hot surfaces.
 Paint only in dry weather.
Product Information
Colors — Standard:
TP2210 – White
TP2202 – Red
TP2220 – Black
TP2242 – Handicap Blue
Technical Data
White
Vehicle Type
Vinyl Acrylic Latex
Pigment Type
Titanium Dioxide
Volume Solids
33.9 ± 1.0%
4 inch line (10.2 cm)
680 – 960 feet long
Recommended Film
Thickness
– Wet
5.0 – 7.0 mils
– Dry
1.7 – 2.4 mils
Theoretical Spread Rate per gallon shown here will vary
depending upon the amount of thinning and the
application procedure.
Dry Time @ 72 °F
(22 °C) @ 50% RH
@ 8 mils
– To Touch
30 Minutes
– Tack Free
30 Minutes
– To Recoat
4 Hours
High humidity and cool temperatures will result in longer
dry, recoat and service times.
Dries By
Evaporation
Viscosity
80 – 85 KU
Flash Point
200 °F or greater
(TT-P-141, Method 4293)
Gloss / Sheen
Flat (1 – 3 @ 85°)
Surface Temperature
at Application
– Min.
50 °F (10 °C)
– Max.
95 °F (35 °C)
Thin With
Clean Water
Clean Up Thinner
Warm, Soapy Water
Weight Per Gallon
11.7 lbs.
Storage Temperature
– Min.
45 °F (7.2 °C)
– Max.
95 °F (35 °C)
Volatile Organic Compounds (VOC)
93.8 Grams/Liter 0.78 Lbs./Gallon
— Tint Bases:
N/A
— Special Colors:
Contact your retailer
Certifications & Qualifications:
The products supported by this data sheet contain a maximum of 100 grams
per liter VOC/VOS (0.82 lbs/gal.) excluding water and exempt solvents.
This product is compliant under the Ozone Transport Commission regulations
as a Traffic Marking Paint.
Master Painter Institute MPI # 97
LEED (Leadership in Energy and Environmental Design) does not address
Traffic Marking Coatings.
Technical Assistance:
Available through your local authorized independent Insl-x retailer.
For the location of the retailer nearest you, call 1-866-708-9180, or
visit www.insl-x.com
◊ Reported values are for White. Contact dealer for values of
other bases or colors.