User's Guide

29
FCC Compliance Statement
This device complies with part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful
interference, and
(2) This device must accept any interference
received, including interference that may
cause undesired operation.
Operation of this device in the 5150-5250 MHz
band is restricted to indoor use only.
CAUTION: The grantee is not responsible for
any changes or modications not expressly
approved by the party responsible for
compliance. Such modications could void the
user’s authority to operate the equipment.
NOTE: This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed
to provide reasonable protection against
harmful interference in a residential
installation. This equipment generates, uses,
and can radiate radio frequency energy, and if
not installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment o and on, the
user is encouraged to try to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
Regulatory Notices
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit dierent from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/
TV technician for help.
This equipment has been tested and meets
applicable limits for radio frequency (RF)
exposure. This transmitter must not be co-
located or operating in conjunction with any
other antenna or transmitter.
For body worn operations, this Vision MARK-
1 has been tested and meets the FCC &
ISED RF exposure guidelines for use with an
accessory that contains no metal and the
positions the Vision MARK-1 a minimum of 0
cm from the body. Use of other accessories
may not ensure compliance with FCC & ISED
RF exposure guidelines. The highest SAR value
for the Vision MARK-1 as reported to the FCC
and ISED when tested for use at the body is
0.774W/kg and 0.907W/kg.
CAUTION: Changes or modications not
expressly approved by the party responsible
for compliance could void the user’s authority
to operate the equipment.
Canadian Compliance Statement
NOTICE: This Class B digital apparatus
complies with Canadian ICES-003.
This device contains license-exempt
transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic
Development Canada license-exempt RSS(s).
Operation is subject to the following two
conditions:
(1) This device may not cause interference.
(2) This device must accept any interference,