Installation Care and Use Manual

ManualsBrandsInSinkErator ManualsHot Water DispenserHC-View-SS Instant Hot Water Dispenser with Hot and Cool Levers, All-Metal Construction, Tool-Free Tank Connections, Dry Start Protection and 2/3 gal. Stainless Steel Tank Included: Satin Nickel

1

2

3

4

5

6

7

8

9

Property Damage: Do not pinch or break copper

tubing. Do not distort the last 1 inch of tubing.

Make sure to use fiber gasket

to ensure proper seal.



Unpack dispenser components.



On a firm, flat surface, carefully

straighten the copper tubing using

hands only.

 Ensure that the fiber gasket is

properly seated against the base

of the dispenser head.

2

B

A

Fiber

Gasket

H770

H770

 From below the sink, place semi-

circular metal mounting plate over

the mounting screw, ensuring the

mounting plate covers the sink hole.

 Slide washer over so that the screw

is now inside the smaller hole.

Tighten the screw until snug.

 Feed tubes down the hole in the sink

or countertop until the base is at rest

on the sink or countertop surface.

 Position faucet head at the

desired angle.

Half moon shaped metal mounting plate

should cradle all descending tubes.

An assistant may be needed to hold

the dispenser head in place

while securing the dispenser.

C

D

H770

H770

DO NOT remove mounting screw or

fiber gasket from base of dispenser.

9

INSTALLING THE FAUCET - H770