Installation Guide

1
1
⁄4" Hole
Cast Iron or
Hole larger than 1
1
⁄4"
1
2
3
Brass N
ut
Fer
rule
Brass Insert
Wing Nut
Plug
Fiber
Washer
Brass N
ut
Fer
rule
Wing Nut
Fiber
Washer
1
2
3
Brass N
ut
Fer
rule
Brass I
nsert
Wing Nut
Plug
Fiber
Washer
Brass Nut
Fer
rule
Wing Nut
Fiber
Washer
nn
Unpack dispenser components.
nn
On a firm, flat surface, carefully
straighten the copper tubing.
nn
Remove the wing nut from
the valve body.
nn
Make sure faucet head is at the
desired angle.
nn
Slide the 2
1
⁄4" fiber washer over the
faucet threads under the sink and
then tighten the assembly using the
plastic wing nut.
nn
For a 1
1
⁄4" sink hole, stack the
washers in this order:
1) 1
5
⁄8" rubber washer
2) 1
5
⁄8" stainless washer or the
2
1
⁄4" colored steel washer.
For a cast iron sink, or a hole larger
than 1
1
⁄4", stack the 1
5
⁄8" rubber
washer with the 2
1
⁄4" colored
steel washer.
nn
Feed tubes down through the hole
in the sink or countertop until the
base is at rest.
HC MODELS ONLY
nn
Remove plug from the Y-shaped
quick-connector by depressing
release ring. Attach the quick
connector to the ends of the copper
tubes running from the dispenser.
Property Damage: Do not over tighten
the plastic wing nut.
An assistant may be needed to hold
the dispenser head in place
while securing the dispenser.
2
B
A
C
D
View / Wave
View / Wave
View / Wave
View / Wave
1
2
3
Brass Nut
Ferrule
Brass Insert
Wing Nut
Plug
Fiber
Washer
Brass Nut
Fer
rule
Wing Nut
Fiber
Washer
Make sure to use rubber washer
to ensure proper seal.
Property Damage: Do not pinch or break copper
tubing. Do not distort the last 1 inch of tubing.
INSTALLING THE FAUCET - VIEW/WAVE
9
1
2
3
Brass Nut
Ferrule
Brass Insert
Wing Nut
Plug
Fiber
Washer
Brass Nut
Ferrule
Wing Nut
Fiber
Washer
1
2
3
Brass Nut
Ferrule
Brass Insert
Wing Nut
Plug
Fiber
Washer
Brass Nut
Ferrule
Wing Nut
Fiber
Washer
1
2
3
Brass Nut
Ferrule
Brass Insert
Wing Nut
Plug
Fiber
Washer
Brass Nut
Ferrule
Wing Nut
Fiber
Washer
HC models only