Installation Guide

8
1
2
3
Brass Nut
Ferrule
Brass Insert
Wing Nut
Plug
Fiber
Washer
Brass Nut
Ferrule
Wing Nut
Fiber
Washer
nn
Unpack dispenser components.
nn
On a firm, flat surface, carefully
straighten the copper tubing.
nn
Remove the wing nut from
the valve body.
nn
Make sure faucet head is at the
desired angle.
nn
Slide the 2
1
⁄4" fiber washer over the
faucet threads under the sink and
then tighten the assembly using the
plastic wing nut.
nn
For a 1
1
⁄4" sink hole, stack the
washers in this order:
1) 1
5
⁄8" rubber washer
2) 1
5
⁄8" stainless washer or the
2
1
⁄4" colored steel washer.
For a cast iron sink, or a hole larger
than 1
1
⁄4", stack the 1
5
⁄8" rubber
washer with the 2
1
⁄4" colored
steel washer.
1
2
3
Brass Nut
Ferrule
Brass Insert
Wing Nut
Plug
Fiber
Washer
Brass Nut
Ferrule
Wing Nut
Fiber
Washer
nn
Feed tubes down through the hole
in the sink or countertop until the
base is at rest.
HC ONLY
nn
Remove plug from the Y-shaped
quick-connector by depressing
release ring. Attach the quick
connector to the ends of the copper
tubes running from the dispenser.
1
2
3
Brass Nut
Ferrule
Brass Insert
Wing Nut
Plug
Fiber
Washer
Brass Nut
Ferrule
Wing Nut
Fiber
Washer
Property Damage: Do not over tighten
the plastic wing nut.
An assistant may be needed to hold
the dispenser head in place
while securing the dispenser.
2
B
A
C
D
HC /GN
HC /GN
HC /GN
HC /GN
1
1
⁄4" Hole
Cast Iron or
Hole larger than 1
1
⁄4"
1
2
3
Brass N
ut
Fer
rule
Brass Insert
Wing Nut
Plug
Fiber
Washer
Brass N
ut
Fer
rule
Wing Nut
Fiber
Washer
1
2
3
Brass N
ut
Fer
rule
Brass I
nsert
Wing Nut
Plug
Fiber
Washer
Brass Nut
Fer
rule
Wing Nut
Fiber
Washer
1
2
3
Brass Nut
Ferrule
Brass Insert
Wing Nut
Plug
Fiber
Washer
Brass Nut
Fer
rule
Wing Nut
Fiber
Washer
HC only
Make sure to use rubber washer
to ensure proper seal.
Property Damage: Do not pinch or break copper
tubing. Do not distort the last 1 inch of tubing.
INSTALLING THE FAUCET - HC/GN