User manual

24
PROPERTY DAMAGE
Ensure that the control center voltage and phase
match the disposer motor and electrical supply.
Check nameplates on disposers and control
centers for voltage and phase specification.
The disposer motor wiring connection is shown in
the disposer terminal box.
120 V
1-phase
1/2 to 2 HP
208/230 V
3-phase
Call Toll Free 1-800-845-8345
for the nearest InSinkErator
Authorized Service Agency or
to reach Technical Support.
ELECTRICAL SHOCK
Turn off the electrical supply to the disposer before
attempting any work on it. Use a voltmeter or
circuit tester to ensure that power is off.
Installation must conform to local electrical codes.
All components (disposer, WX, control center
and solenoids) must be carefully and permanently
grounded.
A properly fused disconnect must be installed at
the electrical supply source for the control center.
Waste Xpress 208/230V, 3Phase System Wiring Diagram