User manual

20
PROBLEM POSSIBLE CAUSE SOLUTION
No water spraying onto
auger screen.
Solenoid valve clogged.
Water turned off.
Solenoid valve defective.
Spray nozzles clogged.
Timer defective.
Timer not set properly.
Solenoid valve installed incorrectly.
Remove clog.
Turn on water.
Call for service.
Replace nozzles.
Call for service.
Call for service.
Reinstall solenoid valve so arrow is pointing
in correct direction.
Water flows continuously before
controls are turned on.
Solenoid valve is stuck open.
Solenoid valve installed incorrectly.
Solenoid valve is wired incorrectly.
Timer is defective.
Timer is not set properly.
Solenoid valve is defective.
Post flush setting in control center
is not correct.
Call for service.
Reinstall the water solenoid valve with the
arrow on the valve pointing in the direction
of the water flow.
Call for service.
Call for service.
Call for service.
Replace solenoid valve.
Call for service.
Overload protector trips frequently. Disposer is overloaded with
food waste.
Do not overload disposer with excessive
amounts of food waste.
Cold water shuts off when Waste
Xpress shuts off.
System being shut down using Line
Disconnect switch on control center.
Post Flush settings on circuit board in
control center are not to specification.
Use stop and start push buttons. Line
Disconnect switch is only de-activated
when system maintenance is required.
Call for service.
SYSTEM TROUBLESHOOTING
Troubleshooting