Mounting Adapter Guide
FLANGE
SINK MOUNT
A
B
  Waste King, ISE, Toledo, National  4½"  5-1/8"  11327A  Discard previous adaptor parts.
  FMC, Avant  4-5/8"  5-1/8"    11378  Re-use split ring.
  FMC, Avant  5¼"  5-11/16"  11327C  Discard previous adaptor parts.
  Bus Boy  6"  6-7/8"  11327K  Discard previous adaptor parts 
          (has 3-piece split ring).
  ISE, Toledo  6"  7-3/16"  11327B  Discard previous adaptor parts.
  Standard ISE mounting  6-5/8"  7-1/8"  11599E  Discard previous adaptor parts.
  National, Hobart, Toledo  7"  7-3/8"  11327G  Discard previous adaptor parts.  
          National mounting has ten 
          bolt circle on split ring.
  Salvajor  7"  7¾"  11599A  Discard previous adaptor parts  
          (split ring supplied).
  ISE, Toledo  8"  9¼"  11327  Discard previous adaptor parts 
          (split ring supplied).
Normally Used By A B
ISE Ring
Adaptor #
Special Information
A – Diameter (sink or bowl opening)
B – Diameter (outside flange)
1
A
E
B
  Waste King, Red Goat  4½"  6½"  5½"  6  11599  Discard previous 
              adaptor parts. Use 
              existing bolt holes.
  American Delphi, Atomic  6"  7½"  6-7/8"  6     11378D  Discard previous
              adaptor parts. Use 
              existing bolt holes.
  National, Hobart  7"  8½"  8-1/16"  10  11599B  Discard previous
              adaptor parts.
  Hobart  9"  12-1/8"  11-1/8"  8  11327E  Discard previous 
              adaptor parts. Use 
              existing bolt holes.
Normally Used By A E
No. of
Bolt Holes
B
Special
Information
ISE Ring
Adaptor#
A – Diameter (sink or bowl opening)
B – Diameter (outside flange)
E – Diameter (bolt hole circle)
2
A
B
BOLT 
HOLES IN 
UNATTACHED
RING
  Waste King  6"  6½"  11327D  Loose ring on sink not used with 
          this adaptor (O.D. of loose ring is 
          7½" with six bolts – 7" bolt hole 
          circle diameter).
Normally Used By A
B Special Information
ISE Ring
Adaptor No.
A – Diameter (sink or bowl opening)
B – Diameter (outside flange)
3
A. Disconnect existing disposer from sink bowl or cone.
B. Find the diagram that matches your sink bowl or cone.
C. Measure the A and B dimensions (also C, D and E if indicated).
D. Match the manufacturer and dimensions to find the adaptor number to order.
Use This Chart to Select the Right InSinkErator Mounting Adaptor




