Dimensions Guide

Model
F-201R Replacement Filter
For cleaner, fresher-tasting water
Submittal Sheet
Job Specifications
Instant Hot Water Dispensers
HWD426-12F-45-10 Printed in USA
Dimensions
• Includes 2 replacement filters for use
with InSinkErator water filtration system
• Reduces Chlorine, taste and odor for
clean, refreshing taste
• Sanitary, quick-change filter cartridge
makes replacement easy. A simple twist
is all it takes!
• 6 month recommended filter
cartridge replacement
REPLACEMENT ELEMENT
3-1/4 "
8-3/4 "
The Next
Necessity
™
Specifications
Filter Capacity
Temperature
Range
Pressure
Flow Rate
Shipping Weight
500 gallons
30-125 psi
0.75 gpm
Approximately 2.0 lbs.
Incoming cold water
supply line can be
from 33˚F to 100˚F
(1˚C to 38˚C).
Connect to cold water
supply line only.
F-201R Chemical & Mechanical Reduction Filter Specifications: This cartridge provides mechanical and
chemical reduction of dirt/rust, chlorine taste and odor, and particulates.
Filter Capacity: 500 gallons, depending on local water conditions. Note that while the testing was performed under
standard laboratory conditions, actual performance may vary. Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before or after the system. For cold water use only. Systems must be
installed and operated in accordance with the Manufacturer’s recommended procedures and guidelines. See warranty
card for warranty. For service and parts, contact your local dealer or InSinkErator
®
directly at 1-800-558-5700.
Application guidelines/Water Supply Parameters for NSF Testing: Service flow of 0.75 gpm, community or private
well water supply, water pressure of 20-120 psi, water temperature of 33˚F–100˚F. Except as noted, all testing
performed at pH = 7.5 ± 0.5, Flow: 0.75 gpm, Pressure: 60 psi, Temp: 20˚± 3˚C.
Contact an authorized InSinkErator ser
vice agent for repairs or replacement components.
Pressure: 30-125 psi
Temperature: 33
º
F - 100
º
F
Flow Rate: 0.75 gpm
Capacity: 500 gallons
Tested and Certified by NSF International for use in the
F-201 system against NSF/ANSI Standard 42 for the reduction
of Chlorine taste and odor and Nominal Particulate Class I.
Particle Size = 0.5 to 1 um
,
1-800-558-5700
USA
Canada
www.insinkerator.com
1-800-561-1700
www.insinkerator.ca
The Emerson logo is a trademark
and a service mark of Emerson Electric Co.
InSinkErator may make improvements and/or changes
in the specifications at any time, in its sole discretion,
without notice or obligation and further reserves the
right to change or discontinue models.
©2012 InSinkErator, a business unit of
Emerson Electric Co. All Rights Reserved.