Point-of-Use Water Heater Owner’s Manual Installation, Care & Use Instalacion, Cuidado & Uso Installation, Sion & Utilisation 1.800.558.5700 www.insinkerator.com 43969 Rev. A The Emerson logo is a trademark and service mark of Emerson Electric Co. Printed in USA © 2007 InSinkErator, a division of Emerson Electric Co. All Right Reserved.
W152 SPECIFICATIONS T & P VALVE (PRE-INSTALLED ON SOME MODELS) HOT WATER OUTLET (½" NPT FEMALE) W152 Bronze Tank Construction COLD WATER INLET VALVE (NOT SUPPLIED) 2.5 gallons Tank Volume ON-OFF SWITCH W154 120 volts Voltage COLD WATER INLET (½" NPT FEMALE) 1500 watts Heating Capacity Replaceable copper/bronze* Element Type ACCESS COVER 4 gallons Temperature Range 110˚F - 170˚F Operating Pressure 150 psi (max.
WHAT YOU SHOULD KNOW BEFORE YOU BEGIN When using electrical appliances, basic safety precautions to reduce the risk of fire, electric shock or injury to person should be followed, including: ■ This heater must only be installed or serviced by qualified persons with ability equivalent to that of a licenced tradesman in the field involved. ■ For your satisfaction and safety, read all instructions, cautions, warnings and dangers before installing or using this water heater.
2A MOUNTING THE TANK - W152 The W152 model is designed for wall or floor mounting. ■ Select a spot to mount water heater vertically, with water connection at the top. ■ Water heater must be located within 3-1/2 ft. of a grounded 120-volt electrical outlet. 2A vertically, with water connection at the top. ■ Water heater must be located within 3-1/2 ft. of a grounded 120-volt electrical outlet. 3½" ■ Ensure wall or cabinet is strong (full tank) 34 lbs.
3A CONNECTING TO WATER SUPPLY ■ Locate the cold water inlet identified INLET. 4A FILLING THE TANK ■ Locate the hot water drain screw at the front-bottom of the tank. ■ Ensure the dip tube, supplied to carry ■ Ensure the screw is tight by turning cold water from the tank top to the bottom, is in the cold water inlet. clockwise with a screwdriver. ■ Connect the cold water line to the 1/2" NPT female fitting on the top of the heater (use Teflon tape on threaded connections).
This appliance must be grounded. In the event of a malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This appliance is equipped with a cord having an equipment grounding conductor and a grounding plug. The plug must be plugged into a three pin receptacle that is properly installed and grounded in accordance with all local codes and ordinances.
WARRANTY INFORMATION Water Heater: 1-year warranty Tank: 5-year warranty on bronze tank Full Residential Water Heater Warranty Full One-Year Warranty. InSinkErator warrants that the water heater will be free from defects in material or workmanship for a period of one (1) year after date of original installation. If during this one-year period, the water heater is found to have any such defect, InSinkErator will repair or replace it at no charge. Limitations.
Please read Troubleshooting Guide and/or visit www.insinkerator.com before calling AnswerLine™ WIRING DIAGRAM TROUBLESHOOTING 3 WIRE POWER CORD 110-120 VAC Always remove the power cord from its receptacle before servicing the heater. ORTANT: If the heater stops working: SIDE CORD FTECORD ■ OF Check the circuit breaker supplying power to the outlet where the heater is installed.
