Installation Guide

Mounting Adaptor (#11599-K)
Installation Instructions
(SUPPORT LEGS ARE REQUIRED)
1. Assemble the rubber sleeve (2) to the
throat of the sink bowl with one of the
clamping bands (1).
2. Insert the lip of the sleeve adaptor (3)
through the mounting flange (4) and
into the groove of the mounting
gasket (5).
3. Place the sleeve adaptor (3), mounting
gasket (5) and mounting flange assembly
on top of the disposer body flange. Be
certain that the threaded fasteners in
the mounting flange (4) fit into the
recesses in the top of the mounting
gasket (5).
4. Fasten six screws (6) through holes
in disposer body flange, mounting
gasket (5), and into the threaded
fasteners in the mounting flange (4).
Tighten screws evenly.
5. Position the disposer under the rubber
sleeve (3). Extend the adjustable legs of
the disposer to provide support from
the floor.
NOTE: Disposers from 3 H.P. through
10 H.P. have factory assembled legs.
Disposers from 1/2 H.P. through 2 H.P.
require two accessory legs.
6. Turn the disposer into position for
plumbing connections. Slide the sleeve
adaptor (3) into the bottom of the rubber
sleeve (2) and tighten with the other
clamping band (1). Adjust the support
legs for final positioning.
Part No. 13966-T October 2007
This adaptor will fit a sink opening of: 8" I.D. and NO FLANGE
(1) Clamping Band
(#13119)
(3) Sleeve Adaptor
(#13118)
(4) Mounting Flange
(#11004-C)
(5) Mounting Gasket
(#11341)
(6) Screw
(#1491)
(1) Clamping Band
(#13119)
(2) Rubber Sleeve
(#13120-A)
Disposer
Body Flange
Threaded Fasteners
Throat
Keyholes
Sink