Installation Guide

1. Place mounting flange (1) up over
existing sink bowl connection lip. It may
require a slight force fit. Do not use
existing LOOSE RING.
2. Push mounting flange (1) up out of the
way and fit inside groove of mounting
gasket (2) onto the sink bowl
connection lip.
3. Move mounting flange (1) down over
mounting gasket (2). Be certain that the
threaded fasteners in the mounting
flange (1) fit into recesses in the top of
the mounting gasket (2).
4. Attach two screws (5) through opposite
holes in the flat gasket (4), support
ring (3), mounting gasket (2) and into
the threaded fasteners in the mounting
flange (1). The screws (5) should be
protruding approximately 1/4 inch below
the flat gasket (4).
5. Position the disposer beneath the flat
gasket (4) and engage the two
protruding screws in the keyhole slots
in the disposer body flange. Assemble
the remaining four screws (5) and turn
the disposer into place for plumbing
connections. Tighten all screws evenly
to secure the unit.
Mounting Adaptor (#11327-D)
Installation Instructions
13966-D REV A
This adaptor will fit a sink opening of: 6" I.D. and 6-1/2" O.D.
Sink Bowl
Connection Lip
Threaded Fasteners
(1) Mounting Flange
(#11004-B)
(3) Support Ring
(#14726)
(4) Flat Gasket
(#11292)
(5) Screw
(#1491)
(2) Mounting Gasket
(#11342)
Disposer
Body Flange
Keyholes
Sink