Installation Guide

13966-A REV A
1. Place mounting flange (1) up over
existing sink bowl connection lip. It may
require a slight force fit.
2. Push mounting flange (1) up out of the
way and fit inside groove of mounting
gasket (2) onto the sink bowl
connection lip.
3. Move mounting flange (1) down over
mounting gasket (2). Be certain that the
threaded fasteners in the mounting
flange (1) fit into recesses in the top of
the mounting gasket (2).
4. Attach two screws (5) through opposite
holes in the flat gasket (4), support
ring (3), mounting gasket (2) and into
the threaded fasteners in the mounting
flange (1). The screws (5) should be
protruding approximately 1/4 inch below
the flat gasket (4).
5. Position the disposer beneath the flat
gasket (4) and engage the two
protruding screws in the keyhole slots in
the disposer body flange. Assemble the
remaining four screws (5) and turn the
disposer into place for plumbing
connections. Tighten all screws evenly
to secure the unit.
Mounting Adaptor (#11327-A)
Installation Instructions
This adaptor will fit a sink opening of: 4-1/2" I.D. and 5-1/8" O.D.
Sink Bowl
Connection Lip
Threaded Fasteners
(1) Mounting Flange
(#11004-A)
(3) Support Ring
(#14724)
(4) Flat Gasket
(#11292)
(5) Screw
(#1491)
(2) Mounting Gasket
(#11342-A)
Disposer
Body Flange
Keyholes
Sink