User Manual
Table Of Contents
- IMPORTANT SAFETY PRECAUTIONS
- IMPORTANT SAFETY INSTRUCTIONS
- FOR YOUR SAFETY
- Additional safety instructions
- SAVE THESE INSTRUCTIONS
- Features
- INSTALLING
- Selecting a location
- Electrical requirements
- Installing your range
- OPERATING INSTRUCTIONS
- Before you begin using your range
- Using the surface burners
- Using the oven
- Minimum and maximum settings
- Positioning the oven racks
- Using the oven vent
- Using the oven light
- Tips for baking
- Setting the clock
- Selecting the 12-hour or 24-hour display setting
- Using the timer
- Baking
- Adjusting the thermostat
- Fan baking and roasting
- Programming the cook time
- Programming a delayed start time
- Broiling
- Keeping food warm
- Switching between Fahrenheit or Celsius
- Turning sound on or off
- Locking oven controls
- MAINTENANCE
- Cleaning and maintenance
- Using the oven vent
- Cleaning the control panel
- Cleaning painted parts and decorative trim
- Cleaning stainless steel surfaces
- Cleaning the oven racks
- Cleaning the oven door
- Cleaning the surface element control knobs
- Cleaning the cooktop
- Removing and replacing the oven door
- Removing and replacing the storage drawer
- Steam cleaning the oven
- Troubleshooting
- Specifications
- ONE-YEAR LIMITED WARRANTY
www.insigniaproducts.com
16
Installing your range
Tools you need (not included)
Items not included
• 4-wire or 3-wire power cord
•Strain relief
Notes to the installer:
1 Read this manual before installing your range.
2 Observe all governing codes and ordinances.
3 Make sure that you keep these instructions with your range.
4 Before installing your range in an area covered with linoleum or any synthetic floor covering, make sure that the floor
covering can withstand temperatures of at least 180°F (82°C) without shrinking, warping, or discoloring.
5 Do not install your range over carpeting unless you place an insulating pad or sheet of .25 in. (.6 cm) thick plywood
between your range and carpeting.
Before installing your range
1 Remove the exterior and interior packing.
2 Wipe the surfaces of your range with a damp cloth or sponge, then wipe them dry with a clean, dry cloth.
This range can be connected directly to the circuit breaker box (or fused disconnect) through flexible or nonmetallic
sheathed, copper cable.
Allow 2 to 3 ft (61 cm to 91.4 cm) of slack in the line so that the range can be moved if servicing is ever necessary.
A UL listed conduit connector must be provided at each end of the power supply cable (at the range and at the junction
box).
Wire sizes and connections must conform with the rating of the range.
The wiring diagram is located on the rear panel.
WARNING: We recommend that a professional installer install your range.
If your range is not installed correctly, incorrect electrical grounding can cause a fire or explosion which can lead to injury or death.
Range rating*
Specified rating of power
supply cord kit and circuit
protection
120/240 Volts 120/208 Volts Amps
8.8 – 16.5 KW 7.8 – 12.5 KW 40 or 50**
16.6 – 22.5 KW 12.6 – 18.5 KW 50
Phillips screwdriver
Pliers
1/4 in. nut driver
Pencil
Drill
Adjustable
wrench
Level