User Manual

www.insigniaproducts.com
45
4.8 Cu. Ft. Electric Convection Range with Self Clean and Air Fry
4 Press the Start pad. When the operation is complete, the display blinks and a beep sounds.
5 Press the Off/Clear pad.
6 Open the oven door and remove the remaining water with a sponge. Do not leave the residual water in the oven for
any length of time. A significant amount of water remains on the bottom of the oven after a steam-cleaning cycle.
7 Use a detergent-soaked sponge, a soft brush, or a nylon scrubber to wipe the oven interior. Remove stubborn residue
with a nylon scourer. You can remove lime deposits with a cloth soaked in vinegar. If the oven remains dirty, repeat the
procedure after the oven has cooled.
8 After cleaning, leave the oven door ajar at a 15° angle to let the interior enamel surface dry thoroughly.
Troubleshooting
If the solutions in this section do not solve a problem, contact a qualified service technician or Insignia customer service.
Control panel display
Note: If you press the Oven Clean pad when the oven temperature is above 150° F (65° C), Hot appears in the display. Because this
function produces the best results when started while the oven is cool, we recommend that you wait until the oven has cooled down
and Hot disappears from the display.
WARNING: Be careful when opening the door before a steam-cleaning procedure has ended, the water on the bottom is hot.
PROBLEM POSSIBLE CAUSE SOLUTION
My range is not level. Your range has been installed
incorrectly.
• Place an oven rack in the center of the oven.
Place a level on the oven rack. Adjust the
leveling legs at the base of your range until
the oven rack is level.
• Make sure that the floor is level and strong
and stable enough to adequately support
your range.
The floor is sagging or
sloping.
Contact a carpenter to correct the situation.
The kitchen cabinets are not
correctly aligned and make
your range appear to be not
level.
Make sure that the cabinets are square and provide
sufficient room for installation.
My range needs to be
accessed for servicing and
can’t be moved easily.
The oven leg is inside the
anti-tip device.
Slide your range forward until the leg is out of the
anti-tip device, then move your range as needed.
Make sure that you reinstall the range leg into the
anti-tip device when you are through.
The kitchen cabinets are not
square and too close to your
range.
Contact a builder or installer to make your range
accessible.
Carpet is interfering with
movement of your range.
Provide sufficient space so your range can be lifted
over the carpet.
PROBLEM POSSIBLE CAUSE SOLUTION
The display goes blank. A fuse in your home may be
blown or the circuit breaker
tripped.
Replace the fuse or reset the circuit breaker.
The display flashes. There was a power failure. Reset the clock.
The beeper doesn’t work. The beeper sound has been
turned off.
Press and hold the (sound) pad for three
seconds.
I turned off the beeper, but it
still beeps.
Some beep tones can’t be
turned off.
The clock and beep warning tones stay on even
when you turn the beeper off. This is normal.