User Manual
Table Of Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Features
- Setting up your refrigerator
- Connecting the water supply
- Using your refrigerator
- Powering your refrigerator
- Switching between Fahrenheit and Celsius
- Setting the refrigerator temperature
- Setting the freezer temperature
- Using the ice and water dispenser
- Using Super Cool to speed refrigerator cooling
- Using Super Freeze to speed freezing
- Using the Energy Saving mode
- Locking the control panel and dispensers
- Turning off the door alarm
- Using the door baskets
- Using the foldable shelf
- Removing and re-installing the glass shelves
- Opening and closing doors
- Using the drawers
- Maintaining your refrigerator
- Storing your refrigerator
- Moving your refrigerator
- Tips on saving energy
- Troubleshooting
- Specifications
- ONE-YEAR LIMITED WARRANTY
www.insigniaproducts.com
14
Removing and replacing the refrigerator doors (Optional)
If the opening to the installation area you chose is too narrow for your refrigerator to pass through, remove the doors and
drawers, then move your refrigerator sideways into the area.
Removing the refrigerator doors
You need the following tools to remove the refrigerator doors:
1 Make sure that your refrigerator is unplugged.
2 With the refrigerator doors shut, use a Phillips screwdriver to remove the three screws that secure the hinge cover to
the top of your refrigerator, then remove the hinge cover with attached entire harness assemblies.
3 To remove the wire connector on the left door, press the top of the connector and pull it away.
WARNING: Electrical Shock Hazard
Disconnect your refrigerator from power before removing the doors. Reconnect the ground wire before operating. Failure to do so
could result in death or electric shock.
Note: Do not remove the doors unless you have to.
Phillips screwdriver
8 mm wrench
4 mm Allen wrench
Hinge cover
Wire connector