User Manual
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Features
- Assembling your fire table
- STEP 1: Attaching the bracket posts to the table top
- STEP 2: Installing the bottom plate
- STEP 3: Installing the gas cylinder block
- STEP 4: Installing the left side panel
- STEP 5: Installing the door pane assembly
- STEP 6: Installing the side panels
- STEP 7: Preparing and installing the burner assembly
- STEP 8: Adding the lava rocks and table lid (optional)
- STEP 9: Installing the propane tank
- STEP 10: Testing for gas leaks
- Before you begin using your fire table
- Using your fire table
- Maintaining your fire table
- Specifications
- ONE-YEAR LIMITED WARRANTY
www.insigniaproducts.com
20
STEP 9: Installing the propane tank
To make sure that the propane tank is installed correctly, see IMPORTANT PROPANE TANK INFORMATION on page 6.
1 Hold the regulator in one hand and insert the nipple into the valve outlet. Make sure that the nipple is centered in the
valve outlet. The coupling nut connects to the large outside threads on the valve outlet.
2 Hand-tighten the coupling nut clockwise until it comes to a full stop. Firmly tighten by hand only.
3 Slide the propane tank into your fire table and position it in the round tray in the base, then tighten the wing nut that
secures the tank in the tray.
4 Close the door.
WARNING:
• Do not store a spare LP-gas tank under or near this appliance.
• Never fill the tank beyond 80 percent full.
• Place the dust cap on the tank valve outlet whenever the tank is not in use. Use the dust cap that is provided with the tank valve.
Other types of caps or plugs may result in leakage of propane.
• Turn the cylinder valve OFF and replace the cylinder when the gas pressure is low.
Propane supply hose
and regulator assembly
Wing nut